|
Titanium has for some time been one of the materials of choice within the aerospace industry because of its superior strength-to-weight ratio. But the very properties that make titanium an airplane designer's dream, make it a machinist's nightmare. Now, however, with the advent of CoroMill 690 from Sandvik Coromant, there is a dedicated long-edge cutter that is up to the job.
With the new alloy,Ti-5553 replacing the old workhorse Ti6Al4V, the machining challenges ramp up even further. The CoroMill 690 is designed to help you profitably meet these challenges.
If you have a new titanium job coming up in the future or one which you wish to improve upon, please contact your representative at Tool & Abrasive. Just click on the MORE INFORMATION link below.
MORE INFORMATION
HOME
|
|
 |
